English
English

IRCFCIndustrial Infrared Heaters

Infrared heater for spot heating of larges premises

  • White, grey or black

  • With included protective grille

  • Heats only when and where needed

  • Recommended installation height 3-10 m

‌
‌
‌

Pleasant and Silent Comfort

Radiant heaters give an efficient and pleasant heat in the dwelling zone and individual comfort can be created with spot and zone heating. No moving parts mean a silent system that does not cause air movements, creating a hygienic indoor climate and reducing the spread of dust, bacteria, or odours.

Easy and Flexible

IRCFC has an easy and flexible installation and requires a minimum of maintenance. It gives instant heat and no preheating is necessary. The angle of the heater can be adjusted for optimum comfort.

Cost Savings

IRCFC is especially designed for spot heating of premises with large air volumes, such as churches, aircraft hangars and warehouses. Radiant heaters can give cost savings of up to 25% compared to convector heaters, especially in buildings with high ceilings that are used on an irregular basis.

Wide Range

IRCFC has a discreet and compact design. It is equipped with one to three halogen lamps and with glossy finished reflectors. The range includes models with a variety of sizes, colors, outputs, and protection classes.

IRCFC is especially designed for spot heating of premises with large air volumes, such as churches, aircraft hangars and warehouses.

Halogen infrared heater IRCFC is available in three versions:

  • IRCFC white: RAL9015 glossy, fitted with one to three lamps. IP20.

  • IRCFC grey: RAL9006 matt, fitted with one to three lamps. IP20.

  • IRCFC black: RAL9005 matt, fitted with one or two lamps. IP54.

The heaters must be placed so that they cover the area to be heated. Optimum comfort is achieved if the heat is distributed from at least two directions.

IRCFC is installed horizontally on the ceiling or on the wall with the supplied bracket. The IRCFC can also be suspended from the ceiling, e.g. from chains. The angle of the heater can be adjusted for optimum comfort.

IRCFC is intended for permanent installation.

  • Corrosion proof casing of aluminum.

  • A protective grille is included and pre-fitted on each unit.

  • Extra lamps are available as accessories.

To comply with Ecodesign Regulation (EU) 2015/1188 the unit must be installed with thermostat TAP16R. TAP16R has adaptive start, week program and open window detection. Black bulb sensor and presence detector are available as accessories. Please note that a relaybox RB3 is required for IRCFC30/45. For IRCFC45, another compliant alternative is to use relaybox RB123 and presence detector PDK65, instead of TAP16R.

 The product can be controlled in a different way, e.g. by an overall control system (BMS) as long as the requirements of Ecodesign Regulation are met. Regulation for installations not affected by the Ecodesign directive are available as well.